DIY: First Day of Fall Wreath!

Fall is officially here! I've been waiting for scarf and boots weather for MONTHS, and even though it's still 80 degrees outside, it has not deterred me one bit. In order to ring in the fall properly, I decided to make a new wreath for the front door, inspired by this one at Paper Source. But instead of paying $20, you can pretty much make this from scraps you make have lying around the house. 

Here's what you need:

1. Cardboard for creating the wreath ring and the leaf template

2. Fabric and/or paper scraps (I used a mix of fabric, paper, pleather and felt)

3. Hot glue gun and glue sticks

4. Scissors

5. A pen

Optional Supplies:

1. Iron and starch

2. Feathers 

3. Stalks of dried wheat

I started by tracing a dinner plate onto the cardboard, and then a dessert plate inside that circle. I then cut around the outer line and the inner line to give me my wreath form. Then I freehand drew the leaf template and cut that out too.

Then came the tedious part. I traced the leaf onto all the fabric and paper, and cut out millions of little leaves. Okay, it was more like 100, but it felt like millions.

It's not important to have an even number of colors, I wound up using about 12-16 of each (I had 7 different fabrics). You can always cut more if you run out! My fabric was a little wrinkled, so I starched and ironed the leaves, folded them in half longways, and then pressed them again. The crease makes them stand up a bit, and gives the wreath a little more body. 

Next, hot glue your leaves, round-side down, to the outer most part of your wreath form, overlapping the sides just a bit. I tried to use every color equally, without it being too perfect or deliberate. As I went around, I incorporated the feathers and wheat stalks.

You should end up with three rows of leaves on the cardboard ring. For the fourth and final row, glue the leaf onto the ring about halfway up the piece of fabric (instead of on the round bottom), and then fold the round part around to the back of the form and secure it with more glue. This way you'll hide the rough edge of the cardboard. 

When you're all done with that, secure a loop of ribbon or string to the back of your wreath for hanging. Because my wreath is going to end up on a glass door, I finished the back by gluing a ring of the pleather.

I also added a bow to the front, to polish things off. And there you go! A super snazzy new fall wreath! Paper Source, eat your heart out!